Ao-smith BFC - 28 User Manual download pdf (Page 31)

Electrical connection

Release R.1.3 UK 31

In preparation you should first remove the two plastic covers and the

protective cap of the electrical section. The plastic covers are attached to the

appliance by 4 screws and Velcro fastenings. The covers are also joined to

each other with Velcro fastenings.

1. Unscrew the screws of the plastic covers.

2. Carefully remove the black plastic covers from the appliance.

The electrical section is now visible.

3. Undo the 2 screws 1 from the electrical section and remove the protective

cap 2 from the electrical section.

The connection block 3 is now visible.

n Remark

Refer to ’A.2 Electrical diagram BFC’ for the connection of electrical

components.

3.10.3 Mains voltage

The appliance is supplied without a power cord and main switch.

n Remark

In order to receive electrical power, the appliance has to be connected to the

mains voltage by means of a permanent electrical connection. A two-

terminal main switch with a contact gap of at least 3 mm must be fitted

between this fixed connection and the appliance. The power cord must have

cores of at least 3 x 1.0 mm

1. Connect phase (L), neutral (N) and earth (

A) of the power cord to terminals

22 through 24 of the connector block as indicated in Table 3.10.

2. Fit the power cord in the pull relief.

3. If you do not need to make any more connections:

- Fit the cap on the electrical connection block.

- Fit the plastic covers onto the appliance.

Figure 3.6 Connection block (connections 1 through 24 explained in

Tabl e 3.10 )

IMD-0077

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 95 96

No comments

Ao-smith BFC - 28 User Manual Page 31